Garage doors spring repair require a lot of force to open and close, so it’s natural for springs to wear out over time. If you have a broken or worn out spring, it’s best to call a professional for repair.
Depending on the severity of the damage, you can expect to pay between $150 and $350 for a repair job. If you only need to lubricate the springs, you might pay less, but it’s still a significant investment.
Cost
Replacing a single garage door spring typically costs $150 to $350, including the hardware and labor. It can be even higher if you have a multi-door garage and need to replace several springs simultaneously.
The cost of garage door springs is affected by a variety of factors, including the type of springs you have and how often you use them. For example, cheap springs use lower-quality metal coils and may break faster.
Cold climates can also wear out springs more quickly. Keeping the garage door closed and insulated helps shield springs from the cold, and lubricating them with a silicone-based lubricant yearly can help prevent moisture from rusting the coils.
You can save money by converting your extension springs to torsion springs, which last longer and require fewer parts. These conversion kits can be purchased without installation for $50 to $200.
Materials
Garage door springs are a critical part of the system that lifts your garage door. They can be either extension springs (on both sides of the garage door track, most common on light doors), or torsion springs (one or two along the wall above the door opening for heavier doors).
Torsion springs are incredibly dangerous and should only be replaced by trained professionals. They are also expensive.
Extension springs are much less dangerous and can be changed by do-it-yourselfers who have the right tools and know-how. However, it is important to choose a replacement spring that matches the size and winding orientation of the original.
There are many different brands of replacement garage door springs available at hardware stores and online. The most reliable way to ensure you purchase the correct spring is to take measurements of the originals.
Installation
Garage door springs are the most expensive part of the door and need to be replaced about once every 10 years. Replacing them is not a do-it-yourself project; it is dangerous and involves the use of heavy equipment.
Inexperienced people have been injured in the process, and it is recommended that you leave this job to a professional garage door repair company.
Start by removing the torsion springs, cables, and cable drums from the bracket. Then, lubricate the shaft of both torsion springs where it will be rubbing against the stationary cones and the center bracket.
Slide both torsion springs out of the bracket toward the cable drums. Be sure not to break a cone as you go along.
Once the torsion springs are out, remove them from the garage door and unwind each one. Be sure to insert at least one winding bar into the end of the spring and hold it in place with your hand.
Maintenance
The springs in your garage door do a lot of heavy lifting every time you open and close it. Without them, your door would not be able to function properly.
A broken or worn-out spring can make it difficult to open the door, which is why it’s important to get them replaced as soon as you notice that they’re in need of repair.
If you can’t open your garage door manually or it falls down when you try to raise it, this could be a sign that the springs are out of balance.
Torsion springs can be extremely dangerous if you try to repair them yourself, so you should always trust an expert for this task. They have the experience and the tools to perform the job safely, which can prevent a potential injury from happening.